Piston Rebuild Kit
• 2 pre-wound wicks
• 3 replacement screws
• 3 replacement O-Rings
• Resistance: 1.0 ohm +/- (Stock Atomizers)
The Piston™ RDA (Rebuildable Drip Atomizer) by Vapage®
Replacing the coils:
Step 1: Remove vape chamber and loosen the Phillips screws (all three) by one or two turns. With pliers or screwdriver pull old coils off.
Step 2: Place apposing lead wires to each post (one on the positive post, and one on the negative post). Insert them in the hole in the post (Thicker gauge wire may need to be installed on screw shaft) then bend the wire half way around shaft to hold it in place. If building a dual coil, repeat the process on the opposite side as you did the first one.
Step 3: Tighten down the screws making sure that the wires stay connected to the posts. Do not over tighten, just enough to lock the coils in place.
Step 4: After coils are in place and secure, cut the excess wire off—cut as close to the post as you can.
Step 5: check to make sure the coils are a least 0.5mm from post and adjust as necessary. Make sure the coils are level with the top of the posts to achieve proper airflow.
Step 6: Now test to make sure the coils are getting power, install the piston base to your Mod, and do a quick test-fire to see if the coils are heating up. If they are, finish off your build. If not, go back through the steps to see where the problem is.
Step 7: If all is well, assemble the Piston and vape away.